Model Number:KBRG-225D

KBRG-225D (8800), SCR DC Drives, 115/230 Vac Input, 0-90/180 Vdc Output, thru 3 HP, Open Chassis

$396.14
Adding to cart… The item has been added
Series: KBRG
Input Amps AC: 24 Amps
Output Armature VDC: 90 VDC, 180 VDC
Max HP @ 90/180 VDC Armature: 1 1/2 Hp / 3 Hp
Input Phase: 1
Output Field Amps DC: 100 VDC, 200 VDC, 50 VDC
Regen: Yes
Feedback Types: Armature, Tachometer
Operator Controls: Not Available
Package: Chassis
Temperature Range (F): 32-113 °F
Approvals: cUL, UL
Nominal Armature VDC: 90 VDC, 180 VDC
Net Weight: 7 lbs
Product Summary: Operates off 115/230 Volt AC line, 50/60 Hz. Filtered DC output for cooler motor operation, longer brush life, lower audible noise, and wider speed range.

The KBRG™ is a full-wave regenerative drive capable of operating DC PM or Shunt motors in a bidirectional mode. Its 4-quadrant operation provides forward and reverse torque in both speed directions. This allows the control to maintain constant speed with overhauling loads and provides rapid instant reversing and controlled braking. Because of its excellent controllability and response time, the KBRG™ can replace servos in many applications. The control is factory set for armature feedback, which provides up to 1% load regulation over a motor base speed of 50:1. However, tachometer feedback is also available if superior regulation is required. By resetting mode jumper J7 to the “TRQ” position, the KBRG™ can be changed from a speed
control to a torque control. The drive contains a variety of “selectable” jumpers and adjustment trimpots to allow for custom tailoring for exact requirements. For example: jumper J6, when placed in the “TCL” position, provides adjustable timed current limit from 1 to 15 seconds. This feature will protect the motor and control by shutting the drive down after the preset time has elapsed. The KBRG™ can be operated with either a two (2) or three (3) wire start/stop circuit, or can be started from the AC line. A set of dedicated relay contacts are provided which are activated via the start/stop circuit. They can be used to turn on or off corresponding equipment or to sound an alarm if the drive stops. Another important feature is the array of the LED’s,
which indicate the mode of operation the drive is in, and also serve as a diagnostic tool. In addition, KB’s exclusive Auto Inhibit® circuit provides safe, smooth starting during rapid cycling of the AC line. The Overspeed Protect Circuit prevents failure of the power bridge in extreme overhauling conditions. Reliability of the KBRG™ is further enhanced with the use of a high speed current limit circuit along with armature, AC line and control circuit fusing and MOV transient protection. A 5K remote potentiometer and full operating instructions are supplied.

Dimensions: KBRG-225D: 7.70" X 10.00" X 3.50"

**Plug-In Horsepower Resistor® and Armature fuse supplied separately.


Dimensions: 7.70" x 10.00" x 3.50"

Options include Auxiliary heat sink, Barrier Terminal Board, RFI/EMI filters and Signal Isolation.

UL, CSA, CE, C-tick. (CCC pending) Patented.



1 2

kbrg Data Sheet.pdf Download

KBRG-225-KBRG-240D-Manual.pdf Download